Software Set-Up; Installation Of The Hmd Wire Pulley (Giveaway); Software Set-Up Instructions; 1.Kat Gateway Software Introduction - KAT VR Walk C Owner's Manual

18
19
Giveaway
20
21

Installation of the HMD wire pulley (Giveaway) :

01 01
PUSH
Drill a hole in the ceiling about
1m (horizontally) away from the
center of the treadmill. Place
the expansion screw sleeve into
the hole.

Software Set-Up

Software set-up instructions

1.KAT Gateway Software Introduction

KAT Gateway is an independent software platform designed by KAT VR for the management of
the KAT Walk C.
15
HMD Wire Pulley
Sensor Buckle
Trapezoidal anti-friction stripe
Square anti-friction stripe
02 02
Mount the hook into the expan-
sion screw sleeve, tighten,
Thread the wire harness into the
wire harness.
03 03
Hang the wire pulley onto the hook.
1
1
1
1