Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for IBA ibaDeskline SAS
Summary of Contents for IBA ibaDeskline SAS
- Page 1 SAS iba Industrial Computer Manual Issue 1.3...
- Page 2 Required corrections are contained in the following regulations or can be down- loaded on the Internet. The current version is available for download on our web site http://www.iba-ag.com. Windows® is a label and registered trademark of the Microsoft Corporation. Other prod- uct and company names mentioned in this manual can be labels or registered trade- marks of the corresponding owners.
-
Page 3: Table Of Contents
Maintenance work ..................25 Basic procedure ................... 25 Power supply slide-in module for replacement of redundant power supply unit ......................25 Restoring of a RAID system during operation ..........26 Installing operating system and iba software ..........31 Installation ....................31 Issue 1.3... - Page 4 9.2.4 Partitioning ....................33 9.2.5 Completing installation ................37 Windows Updates ..................38 Antivirus Software ..................38 Installing iba software .................. 38 Device dimensions ..................39 Technical data ....................40 11.1 Main data ....................40 11.2 Electronic components and interfaces ............41 11.3...
-
Page 5: About This Manual
SAS Manual About this manual This manual describes the construction, the use and the operation of the industrial PC ibaDeskline SAS. Target group This manual addresses in particular the qualified professionals who are familiar with han- dling electrical and electronic modules as well as communication and measurement tech- nology. -
Page 6: Used Symbols
Manual ibaDeskline SAS Used symbols If safety instructions or other notes are used in this manual, they mean: The non-observance of this safety information may result in an imminent risk of death or severe injury: By an electric shock! ... -
Page 7: Scope Of Delivery
Manual Scope of delivery After unpacking check the completeness and intactness of the delivery. The scope of delivery includes: Industrial Computer ibaDeskline SAS USB keyboard with PS2 adapter (PS2 + USB) Mouse (USB/PS2), optical Mains cable ... -
Page 8: Versions
SAS Versions ibaDeskline SAS (Xeon E3, Win7 64 Bit, PCIe) with one hard disk, can be upgraded with up to 7 further hard disks ibaDeskline SAS PCI (Core2Quad 9400, Win7 64 Bit, PCI) with one hard disk, can... -
Page 9: Safety Instructions
SAS Manual Safety instructions Designated use The device may be used only for the following applications: Machine test and commissioning of industrial systems Measurement data logging and analysis Applications of ibaSoftware products (ibaPDA, ibaLogic etc.) Proper installation site According to manufacturer's specifications the device can only be installed on an even non-slip installation surface, for example table or rack. -
Page 10: Description
Manual ibaDeskline SAS Description Front view ibaDeskline / ibaDeskline PCI Optical drive with integrated writing function Plug-in slots for hard disks Issue 1.3... -
Page 11: Top View
SAS Manual Top view ibaDeskline ibaDeskline PCI USB 2.0 interfaces 1 + 2 USB 2.0 interfaces USB 3.0 interfaces Headset interface Headset interface Microphone interface Microphone interface Power button Reset button Power button Reset button Issue 1.3... -
Page 12: Rear View
Standard system version ibaDeskline Connections for external devices (keyboard, mouse, network etc.) Slots X21 to X26 (for low-profile iba cards) Slot X2 for hard disk controller Slots X3 to X7 (PCIe) Power supply with switch and panel plug for non-heating appliances... - Page 13 Manual ibaDeskline PCI Connections for external devices (keyboard, mouse, network etc.) Slots X21 to X26 (for low-profile iba cards) Slot X1 for hard disk controller Slots X2, X4 to X7 (PCI), whereas X3 (PCIe) for special graphic card Power supply with switch and panel plug for non-heating appliances...
-
Page 14: Version With Redundant Power Supply
RAID systems are equipped with a redundant power supply unit. ibaDeskline is shown as example below. Connections for external devices (keyboard, mouse, network etc.) Slots X21 to X26 (for low-profile iba cards, e. g. output connections of FOB-4i cards) Slot X2 for hard disk controller Slots X3 to X7 (PCIe) 2x Power supply with switch and panel plug for non-heating appliances, replaceable Issue 1.3... -
Page 15: Internal View
SAS Manual Internal view ibaDeskline Power supply unit (redundant for RAID systems) PCIe slots Hard disk controller Slots for low-profile iba cards Drive bracket Fan ( Ø 12 cm) Internal USB port (dongle) Issue 1.3... - Page 16 Manual ibaDeskline SAS ibaDeskline PCI Power supply unit (redundant for RAID systems) PCI slots Special graphic card, optional Hard disk controller Slots for low-profile iba cards Drive bracket Fan ( Ø 12 cm) Internal USB port (dongle) Issue 1.3...
-
Page 17: Error Monitoring
SAS Manual Error monitoring The temperature and the status of the power supply unit can be monitored with the slot cards ibaOut-Temp and ibaOut-State. The cards can be ordered separately as acces- sory. If the card is ordered with ibaDeskline, it is installed by default in slot X21. -
Page 18: Ibaout-Temp
Manual ibaDeskline SAS 5.5.1 ibaOut-Temp ibaOut-Temp provides two relay outputs for temperature and power supply (2-pin con- nector), which can be used to indicate errors. Both error types are indicated separately. The switch position of the outputs is as follows:... -
Page 19: Ibaout-State
SAS Manual 5.5.2 ibaOut-State ibaOut-State provides an output (6-pin connector) which can be used to indicate errors. Both error types are indicated separately. These are the switch positions: Switch state switch state Power OK, Power off or temperature OK... -
Page 20: Installation, Connection And First Switching On
Manual ibaDeskline SAS Installation, connection and first switching on Safety instructions Electric Shock! Never use the device with a damaged mains cable! Connect the device to one supply voltage only according to specifications on the built- in power supply unit! -
Page 21: Connection And First Switching On
SAS Manual Connection and first switching on Note Before switching on the device for the first time check if the power supply is connected properly and the connecting cable (fiber optic and copper data cable) are plugged. The device is delivered in a pre-installed and configured state. You can find the parameters of the operating system and ibaSoftware in the corresponding manuals or in the Online Help. -
Page 22: Installation Of Measuring Or Additional Boards
Manual ibaDeskline SAS Installation of measuring or additional boards Safety instructions and notes Electric Shock! Before opening shut down the device! After that disconnect it from the mains and pull out the mains plug from the socket equipped with earthing contact! -
Page 23: Opening The Device
If you want to use an additional monitor with ibaDeskline PCI, it is necessary to install an additional special graphic card. The graphic card has the iba order No. 43.900.511. The DVI/VGA adapter cable is included into the graphic card scope of delivery. - Page 24 Manual ibaDeskline SAS Note iba recommends you to use a graphic card with a bus interface PCI Express x1. The slot supports only this interface version. Special graphic card Chip set: NVIDIA Quadro nView Enabled: Bus Interface: PCI Express x1...
-
Page 25: Maintenance Work
SAS Manual Maintenance work Basic procedure If you carry out any maintenance work at the device, always proceed in the following way: 1. Remove all mobile data carriers (DVD, memory cards and so on). 2. Shut down the device. -
Page 26: Restoring Of A Raid System During Operation
Manual ibaDeskline SAS 1. Loosen the fastening screw which is used to secure the power supply slide-in module at the rack. 2. Pull out the power supply slide-in module. 3. Replace the power supply slide-in module with the module of the same type (availa- ble at iba). - Page 27 SAS Manual 2. Log in as follows: User Name: administrator Password: xadmin 3. A click on <Login> opens the program window of the manager. The defective hard disk is not indicated. 4. Mark the hard disk, which is available (“Device 1” in the example above) and click on the „Locate“...
- Page 28 Manual ibaDeskline SAS 6. The new hard disk is indicated in the „maxView Storage Manager“. But the hard disk has not been registered in the system. 7. Mark the new hard disk („Device 2“ in the example above) and click on the „Initialize“...
- Page 29 SAS Manual 10. Confirm the following overview with <Finish>. 11. The following message appears when the operation was successful. Otherwise an error message appears. Issue 1.3...
- Page 30 Manual ibaDeskline SAS 12. The progress of the rebuild process is displayed under “Tasks”. 13. As soon as the hard disk has been successfully registered in the system, the pro- gram can be closed. Issue 1.3...
-
Page 31: Installing Operating System And Iba Software
Installing Windows Embedded Standard 7 or Windows Server 2008 with the Recovery DVD Important note The Windows Embedded Standard 7 license is bound to the computer the iba software is installed on. The license must not be used on another computer. 9.2.1 General ... -
Page 32: Select The Language
Manual ibaDeskline SAS Note No liability is assumed for the loss of data due to incorrect handling. Always make sure, that you select the correct drives and partitions. Note The recovery process takes approx. 10 minutes. It is possible that only a black or green screen is visible during the process. -
Page 33: Partitioning
SAS Manual Here you can enter optionally the product key. The product key can be changed subse- quently. If you do not enter the product key, you will be asked to confirm. Confirm with <No>. 9.2.4 Partitioning There are several possibilities to set up partitions: ... - Page 34 Manual ibaDeskline SAS Possibility 1: New drive You use a new drive and want to use it completely as system drive. Click <Next> and continue with chapter 9.2.5 „Completing installation“. Possibility 2: Partitioning the new drive You use a new drive and want to set up partitions.
- Page 35 SAS Manual Possibility 3: Recovery Windows Embedded Standard 7 The drive is already in use and you want to install the operating system. 1. Click <Drive Options (advanced)> 2. Mark the system partition 3. Click <Format> 4. Confirm with <OK>...
- Page 36 Manual ibaDeskline SAS The drive is already in use and you want to install the operating system. 1. Click <Drive Options (advanced)> 2. Mark the primary partition (normally the smaller one) 3. Click <Format> 4. Confirm with <OK> 5. Click <Next“> and continue with chapter 9.2.5 „Completing installation“.
-
Page 37: Completing Installation
SAS Manual Possibility 6: Substitute Windows 2008 with Windows Embedded Standard 7 The drive is already in use and you want to replace the operating system. 1. Click <Drive Options (advanced)> 2. Mark the primary partition (normally the smaller one) 3. -
Page 38: Windows Updates
Manual ibaDeskline SAS Windows Updates The automated search for updates is deactivated in iba systems by default. Please adjust the settings according to the update policies in your company. Consult your IT depart- ment if necessary. Antivirus Software There is no antivirus software installed on iba systems in delivery state. Please install the antivirus software package which is used in your company by default. -
Page 39: Device Dimensions
SAS Manual Device dimensions (dimensions in mm) Issue 1.3... -
Page 40: Technical Data
110 V to 374 V DC 8 A/4 A 47 Hz to 63 Hz Max. 400 W Power output ibaDeskline SAS standard 100 V to 240 V AC; 8 A/4 A ibaDeskline SAS RAID 47 Hz to 63 Hz 1 x redundant 500 W... -
Page 41: Electronic Components And Interfaces
5x PCI Express for PCI Express 4x for special graphics iba measuring cards card optionally 5x PCI for iba measuring cards USB 2.0 2 x backside, 2 x topside, 6 x backside, 4 x topside, 1 x inside (dongle) 1 x inside (dongle) USB 3.0... -
Page 42: Products
Products PC systems Order number ibaDeskline SAS, Xeon E3, Win7 64 Bit, PCIe (1 hard disk, can be upgraded with 40.002004 up to 7 hard disks) ibaDeskline SAS PCI, Core2Quad 9400, Win7 64 Bit, PCI (1 hard disk, can be 40.002012... -
Page 43: Support And Contact
Fax: +49 911 97282-33 E-mail: iba@iba-ag.com Contact: Harald Opel Shipping address iba AG Gebhardtstr. 10 DE-90762 Fürth Germany Regional and Worldwide For contact data of your regional iba office or representative please refer to our web site www.iba-ag.com. Issue 1.3...