Advertisement
Security regulations
Warnings!
Only use this device in a well-ventilated place and always wear suitable safety glasses!
Do not touch the molten adhesive or the nozzle (12). Both are very hot during and after
use!
When the adhesive is heated, harmful vapours can be released. Molten adhesive can
cause burns!
Important note:
Oval glue sticks and cold glue sticks must not be used with this device. These glue
sticks have a lower melting point (90–110
controlled sufficiently. Uncontrolled release of adhesive from the body of the unit is a safety hazard
and will cause damage to internal components not covered by the warranty.
Only use glue sticks with a diameter of 11.2 mm for this hot glue gun.
Do not connect the hot-melt glue gun to the mains supply without a glue stick inserted.
Always disconnect the hot-melt glue gun from the power supply before leaving it unattended.
This device must not be operated by people (including children) with limited physical or mental
abilities.
The hot metal nozzle of this hot glue gun must never come into direct contact with flammable
objects such as paper, cardboard, plastic, wood, etc. – Fire hazard!
Operation
1. Mount the support bracket (11) to the hot-melt glue gun using the mounting holes (2).
2. Connect the mains cable (6) to the socket (5) on the charging station.
3. Insert one of the glue sticks (13) into the glue stick holder (7). Push it forward until you feel a
slight resistance.
4. Place the hot-melt glue gun in the charging station (1), making sure that the socket (9) on the
glue gun is firmly seated on the appliance plug (3) on the charging station.
5. Make sure that the charging station with the device is always positioned on a stable, straight
surface in the immediate vicinity of the workpiece.
6. Connect the unit to the mains using the mains cable (6).
7. Wait 3–5 min for the unit to reach its operating temperature.
8. Remove the hot glue gun from the charging station and guide the nozzle (12) over the surface
to be glued.
9. Lightly actuate the transport lever (10) so that the glue stick is pushed forward and melted
glue is dispensed.
10. Release the transport lift to stop the adhesive flow.
11. After the gluing process has been completed, place the device back in the charging station.
Never place the device on its side while it is connected to the mains!
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
℃
), which means that the flow rate of the glue cannot be
Item 61858
Page 4
02
2021-1
Advertisement
