CEN-TECH 57209 Owner's Manual & Safety Instructions page 7

Charging the Jump Starter
WARnInG! TO PREVEnT SERIOUS InJURY:
Always charge on a non-flammable surface.
The Battery Status Indicator Lights show
the battery's power level. Press the Power
Button ON to illuminate the lights.
a. Full and 75%: Green light(s)
indicate ready for use.
b. 50% Charged: Yellow and Red lights
indicate needs to be charged.
c. 25% Charged: Red light indicates
should be charged immediately.
JUMP STARTER
BATTERY STATUS BATTERY STATUS BATTERY STATUS
BATTERY LEVEL
LOW LOW LOW HIGH HIGH HIGH
BATTERY STATUS BATTERY STATUS BATTERY STATUS
BATTERY STATUS BATTERY STATUS BATTERY STATUS
LOW LOW LOW HIGH HIGH HIGH
BATTERY STATUS BATTERY STATUS BATTERY STATUS
LOW LOW LOW HIGH HIGH HIGH
LOW LOW LOW Battery Status Indicator LEDs HIGH HIGH HIGH
1. Turn the Clamp Switch on front of unit to
the OFF position and be sure nothing is
connected to the USB port. The Work Light
and Power Button should be OFF.
note: Before initial use, completely
charge the Jump Starter.
note: Do not operate any of the Jump Starter's
functions while the unit is charging.
2. Connect the included Power Cord's plug
to a grounded 120 VAC 60Hz outlet.
120 VAC 60Hz
Outlet
Item 57209
Fully charged battery
Mostly charged
battery
Partially depleted
battery
Mostly depleted
battery
Power
Cord
For technical questions, please call 1-888-866-5797
3. Remove cover from 120VAC Charging Input
and connect the Power Cord's socket to the
male plug on the side of the Jump Starter .
Power
Cord
Cover
4. The Jump Starter's front panel Charging Battery
LED will illuminate while the unit is charging.
5. The green Battery Status Indicators will
illuminate when the unit is fully charged. Also,
the Maintaining Battery LED will illuminate
until the power cord is disconnected.
Approximate
AC Charge Time
Initial Charge:
Up to 12 hours
Recharge:
Up to 12 hours
Charge Time
6. The Jump Starter must be unplugged
when it is fully charged.
nOTE: FAILURE TO RECHARGE Jump
Starter WILL VOID WARRAnTY.
7. Recharge:
a. When the Battery Status LEDs
indicate 50% or less.
b. After each Jump-Start.
c. Once a month.
DO nOT EXCEED MAXIMUM CHARGInG TIME.
120 VAC
Changing Input
Page 7