Network Configuration Guidelines - Ferroli OMNIA M 3.2 Operation Manual

The FOR SERVICEMAN is used for installer or service
engineer. It is NOT instended the home owener alters
setting with this menu.
It is for this reason password protection is requierd to
prevent unauthorised access to the service settings.
The password is 234.
6.9.3 How To Exit For SERVICEMAN
If you have set all the parameter.
Press ''BACK'', the following page will appear：
FOR SERVICEMAN
Active the setting and exit?
NO
CONFIRM ADJUST
OK
Select ''YES'' and press ''OK'' to exit the FOR
SERVICEMAN.
After exiting the FOR SERVICEMAN, the unit will be
turned off.

6.10 Network Configuration Guidelines

The wired controller realizes intelligent control with a built-in
module, which receives control signal from the APP.
Before connecting the WLAN, please check for it if the router in
your environment is active and make sure that the wired
controller is well-connected to the wireless signal.
During the Wireless distribution process, the LCD icon "
flashes to indicate that the network is being deployed. After the
process is completed, the icon "
6.10.1 Wired Controller Setting
The wired controller settings include AP MODE and RESTORE
WLAN SETTING.
WLAN SETTING
AP MODE
RESTORE WLAN SETTING
ENTER
OK
Activate the WLAN by interface. Go to "MENU"> "WLAN
SETTING"> "AP MODE".
Press"OK", the following page will appear:
YES
"
" will be constantly on.
AP MODE
Do you want to activate the
WLAN network and exit?
NO
CONFIRM
OK
Use '' ''， '' '' to move to"YES", press "OK" to select AP mode.
Select AP Mode correspondingly on the mobile device and
continue the follow-up settings according to the APP prompts.
After enter Ap mode, if it's not connected with mobile
phone, the LCD icon "
disappear.
If it's connected with the mobile phone, the icon "
will be constantly display.
Restore WLAN setting by interface. Go to "MENU"> "WLAN
SETTING" > "RESTORE WLAN SETTING" .
Press"OK", the following page will appear:
RESTORE WLAN SETTING
Do you want to restore the
WLAN setting and exit?
NO
CONFIRM
OK
，
WLAN setting.Complete the above operation and wireless
configuration is reset.
AP Mode connecting WLAN:
6.10.2 Mobile Device Setting
(1) Install APP
①
AP Mode is available for wireless distribution on mobile
device side.
21
YES
CAUTION
" will flash 10 minutes then
"
YES