Preparation; Adding Oil; Checking Oil Level; Changing / Draining Oil - Hyundai HYYW70 Instruction Manual

Preparation

Adding Oil

Oil Type : SAE 30 or 15w40 Engine Oil
Oil Capacity : 600ml
NOTE - The machine is delivered without oil in the engine. All machines are tested and inspected
so there may be some residual oil left in the machine so please fill with caution.
1 Remove the oil filler cap.
2
Fill with fresh SAE 30 or 15W40 engine oil to the upper mark on the
dipstick. DO NOT overfill.
3
Once the correct amount of oil has been added, refit the dipstick securely.

Checking Oil Level

1 Remove the oil filler cap and wipe the dipstick clean.
2
Remove the dipstick and check the oil level. It should be up to the upper mark on the dipstick.
3 If the oil level is too low, add SAE 30 or 15W40 engine oil to the upper mark on the dipstick. DO
NOT overfill. The oil level should not be above the upper mark on the dipstick. If you do overfill,
read the 'Changing / Draining Oil' section below for more information on draining oil.
4
Once the correct amount of oil has been added, refit the dipstick securely.

Changing / Draining Oil

To reduce fire hazards, check there is no oil and/or fuel leaks on a regular basis.
It is highly recommended to change the engine oil every 100 hours or 12 months. This will ensure
the machine will function properly over time.
There are different ways you can empty the oil:
• The oil can be discharged at a specialised servicing centre.
• You can use an oil syringe to suction the oil out through the filler spout, bearing in mind you
may need to repeat the operation several times in order to completely empty the tank.
• Gently tilt the machine with the air filter facing upwards and allow the excess oil to drain from
the dipstick port, in to a suitable container.
Remember to top-up with oil before using the machine again.
19
12