Advertisement
5.
OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1.
!
Ensure the power control switch is NOT locked on before plugging into the mains.
5.1.
Hold the polisher firmly with one hand on the handle grip and the other on the side handle. To select the required speed rotate the
speed selector switch (fig. 5.2) to the required speed 1 to 6.
Speed Settings:
5.1.1. To start the polisher press and hold down the safety lock button (fig.5.1) and squeeze the trigger. When releasing the trigger, the
safety lock button will engage, preventing the polisher from being inadvertently started.
WARNING! the high speed settings are intended for sanding. If used for polishing an excessive amount of surface material may
!
be removed.
Note: As the rubber support disc is flexible, when sanding it should not be used head
on, but at an angle of approximately 10 to 20 degrees.
Contact your Sealey Dealer for details of compound heads and lambs wool
bonnets.
6.
MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is unplugged
!
from the mains power supply.
6.1.
Keep the machine clean and dry. Do not use abrasives to clean the unit. Ensure all
external head screws are tight.
6.2.
Clean regularly by blowing a jet of compressed air through side vents to ensure motor ventilation is kept clear.
WARNING! Wear approved safety eye protection and, if necessary, respiratory protection.
! !
Note. The following maintenance must only be carried out by a technically qualified person or an authorised Sealey service agent.
6.3.
Check carbon brushes by removing each side screw (fig.6). Check to see if the brushes are worn or if cracked. If so, the brush must
be replaced to avoid sparking and damage to the armature. Use only genuine spare parts as these are specifically designed for the
machine. Failure to do so may be dangerous and will invalidate your warranty.
6.4.
After each 500 hours of use replace the gear head grease to prevent gear wear and possible drive failure.
fig. 6
170mm Sander/Polisher
Model MS900PS
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
98/37/EC Machinery Directive
93/68/EEC CE Marking Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
1 = 1400 rpm
2 = 1800 rpm
Declaration of Conformity We, the sole importer into the UK, declare that the product
listed here is in conformity with the following standards and directives.
The construction file for this product is held by the Manufacturer and may be inspected, by a
national authority, upon request to Jack Sealey Ltd.
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Tools.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
3 = 2400 rpm
4 = 2750 rpm
Signed by Mark Sweetman
01284 757500
01284 703534
5 = 3000 rpm
6 = 3200 rpm
2
1
1st March 2005
www.sealey.co.uk
Web
sales@sealey.co.uk
email
MS900PS - 3 - 150806
fig. 5
Advertisement
