90 Day Or 150 Hour Maintenance; (Trained Service Technician); Yearly Or 500 Hour Maintenance (Trained Service Technician) - Snorkel S2755BE Repair Parts Manual

Maintenance Information

90 Day or 150 Hour Maintenance

(Trained Service Technician)

COMPONENTS
Daily maintenance
Preventive inspection
maintenance checklist
Placards & decals inspection
Door hinges and latches
Tie rods
Steer cylinder ends
Batteries
Platform lift capacity
Platform lift/lower speeds
Hydraulic return filter
Engine RPM
Engine oil and oil filter
Engine fuel filter
Slide pads
Scissor arm bearings
Yearly or 500 Hour Maintenance
(Trained Service Technician)
COMPONENTS
90 day or 150 hour maintenance
Hydraulic oil reservoir
Hydraulic return filter
Hydraulic pressures
Platform controller
Base controls
page 10
SERVICE REQUIRED
Perform maintenance as per schedule
Perform inspection, complete form
Inspect using drawing and parts listing
in section 1 (repair parts)
Lubricate
Check pin keeper and condition
Check pin keeper and condition
Check specific gravity
Check if platform can lift maximum
load
Check smooth operation and speeds
Check condition
Check for proper RPM
Replace per engine manufacturer's
interval
Check condition
Check condition
Check condition
SERVICE REQUIRED
Perform maintenance per schedule
Clean and replace fluid
Replace
Check pressures
Check operation
Check operation
Rev C
RECOMMENDED LUBRICANT OR
FURTHER INSTRUCTIONS
Retain copy of checklist
Replace any missing or
unreadable decals/placards
SAE 10W oil or spray lube
DO NOT lubricate
DO NOT lubricate
1.260/1.275 at 80° F.
Replace if dirty
Low = 1750rpm High = 3000rpm
See engine manufacturer's
owners manual
Replace every 6 months or if dirty
DO NOT lubricate
DO NOT lubricate
RECOMMENDED LUBRICANT OR
FURTHER INSTRUCTIONS
Shell Tellus 32 or similar
After 1st. 50 hours, thereafter
at recommended interval
S2755RT, S2255RT – 13715-2