Page 2
If you’re having difficulty, our friendly Customer Care team is always here to help. Call us at 1.888.746.3455 during business hours, email service@article.com or chat live at article.com. REQUIRED TOOL # OF PEOPLE...
Page 3
Page 3 of 16 NERA Bed Structural integrity is warranted only if all fasteners are properly installed & tightened, and the bed is moved only per instructions. DO NOT DRAG BED, ALWAYS LIFT WITH AT LEAST TWO PEOPLE BEFORE MOVING HARDWARE / TOOLS INVENTORY HARDWARE / TOOLS INVENTORY CONT.
Page 4
Page 4 of 16 NERA Bed First remove plastic backing from teflon pads (O). Stick on bottom side of headboard (A) approx. 1/4” in from the edges. × 2...
Page 5
Page 5 of 16 NERA Bed Ensure center beam brackets (C) are level when installed. Use the 4 shortest bolts (Q) provided. × 4...
Page 6
Page 6 of 16 NERA Bed × 6 Holes on compression fitting anchors must be facing inwards on headboard (A). Ensure rubber seal on anchors are tight.
Page 7
Page 7 of 16 NERA Bed × 4 Holes on short compression fitting anchors (S) must be facing down on footboard (B). Ensure rubber seal on anchors are tight.
Page 8
Page 8 of 16 NERA Bed × 4 Holes on short compression fitting anchors (S) must be facing down on side rails (D/E). Ensure rubber seal on anchors are tight.
Page 9
Page 9 of 16 NERA Bed Note placement of holes on each corner piece, left vs. right. S S I T H I S S I T H I × 4...
Page 11
Page 11 of 16 NERA Bed Labels on side rails indicate orientation. THIS SIDE UP × 4 Ensure side rails (D/E) are parallel with footboard (B) when tightening bolts (V).
Page 13
Page 13 of 16 NERA Bed × 4 Unscrew bolts (U) from center leg Attach floating center legs (K) where labels are brackets (J) and floating center legs (K) situated on center beam (I). Ensure that legs before attaching to center beam (I).
Page 14
Page 14 of 16 NERA Bed B O A E A D B O A S ID TH IS E A D S ID TH IS × 2 Adjust levelers on floating center legs Insert pins on center beam brackets to allow for a 3-5mm clearance.
Page 16
Page 16 of 16 NERA Bed × 28 × 14 First, firmly insert pins on Second, firmly insert pins on slat slat clips into side rails. center brackets into center beam. DO NOT DRAG BED, ALWAYS LIFT WITH AT LEAST TWO PEOPLE BEFORE MOVING...
Need help?
Do you have a question about the NERA Bed and is the answer not in the manual?
Questions and answers