Advanced Fat Channel And Voice Effects Controls; High Pass Filter; Noise Gate - PRESONUS revelator Owner's Manual

6 Advanced Features and Customization Tools
6.2

Advanced Fat Channel and Voice Effects Controls

Advanced Fat Channel and Voice Effects Controls
6.2
6.2.1

High Pass Filter

6.2.2

Noise Gate

To open the advanced Fat Channel and Voice Effects Controls, click
on the Advanced button (...) in the Fat Channel section.
To edit any of the effects, click on the name of the desired processor from
the tabs at the top of the screen. This will bring its controls into focus.
Use this control to set the High-Pass Filter frequency threshold for
the selected Channel or Output Bus. The filter's threshold can be set
from 24 Hz to 1 kHz. When the threshold is set to its lowest point,
the filter is off. The high-pass filter's slope is -12 dB/8va.
Power User Tip: A high-pass filter attenuates all frequencies below the set threshold.
Usethe Fat Channel high-pass filter to remove unwanted low frequencies from your
source signal, rather than trying to EQ them out.
1. On/Off. Turns the Noise Gate on or off in the signal chain.
2. Threshold. Sets the signal level that bisects the signals you wish
to keep from the signals you want to attenuate. Signals below
this level are attenuated according to the setting of the Range
parameter. Signals above this level pass through unaffected.
Revelator
Owner's Manual
41