Advertisement
2 Connect the Adaptec AVC-3610 to your set-top boxes, shown in
the Figure in
(B).
a Connect an RF coaxial cable from the TV1 jack on th
AVC-3610
b Connect an RF coaxial cable from the TV2 jack
AVC-3610
!
Caution: Be sure not to plug an RF coaxial cable into the FM
tuner jack.
To improve video quality, you can use S-Video cables or
composite video cables instead of RF coaxial cables to make these
connections. See pages
3 Use two RF coaxial cables to connect the TV In ports on your
set-top boxes to the cable splitter.
4 Connect an RF coaxial cable from the cable splitter to your
wall jack.
5 Connect IR blaster cables from the Adaptec AVC-3610 to your
set-top boxes. You must connect IR blaster cables to be
able to change channels.
a Plug an IR blaster cable into the IR 1 port on the Adaptec
AVC-3610.
Then, peel the protective paper off the emitter end of the
cable and adhere it over, or as close as possible to, the
infrared lens of Set-top Box (A).
b Repeat
Step a
AVC-3610 to Set-top Box (B).
6 Continue with
Step 1 on page 16
to the TV Out port on
to the TV Out port on
18
to
to connect the IR 2 port on the Adaptec
Completing the Setup on page
as Set-top Box (A) and Set-top Box
Set-top Box (A)
Set-top Box (B)
21
for instructions.
17
e
.
on the
.
25.
TV
Advertisement
