Advertisement
2 Connect an RF coaxial cable from
top box to
documentation for help making this connection.
Note: To improve video quality, you can use an S-Video
cable or composite video cable instead of an RF coaxial
cable to make this connection. See pages
instructions.
3 Connect an RF coaxial cable from the TV1 jack on
to the TV Out port on your set-top box.
4 Connect the IR blaster cable from the AVC-3610 to your
box. You must connect the IR blaster cable to be able to
change channels.
a Plug the IR blaster cable into the IR 1 port on the back of the
AVC-3610.
b Peel the protective paper off the emitter end of the cable,
then adhere it over, or as close as possible to, the infrared
lens of your set-top box.
5 Continue with
TV wall jack.
your
Completing the Setup on page
the TV In port on your set-
Refer to your set-top box
14
18
to
21
for
the
AVC-3610
set-top
25.
Advertisement
