Brother TJ-4420TN Setup Manual page 3

8. Fasten the remaining two Screws on the module's Front Cover as illustrated
(fastened by 0.74 N • m ± 0.10 N • m).
NOTE
To open the module's Front Cover, press the button on the side, as
illustrated.
Next, go to section B to install the Internal Liner Rewinder Module.
B. Install the Internal Liner Rewinder Module
1. Remove the four Screws as illustrated, and then remove the Rewind Spindle
Cover.
2. Thread the Power Cable from the PCB side and connect it to the Internal Liner
Rewind Module's power connector.
3. Use the four Screws supplied with the Internal Liner Rewinder Module to
secure it. (fastened by 1.03 N • m ± 0.15 N • m)
Next, go to section C to install the Media Guide Bar and Rear Label Guide
Module.