Page 1
The following page is the instructions for the Light My Bricks LEGO Dom’s Dodge Charger (42111) LED light kit. If you run into any issues, please refer to the online troubleshooting guide. To ensure a trouble-free installation of your light kit, please read and follow each step carefully.
Package Contents: 4x Warm White 30cm Large Bit Lights 2x White 30cm Bit Lights 2x Orange 30cm Bit Lights 6x White 15cm Bit Lights 1x Warm White Strip Light 1x 12-Port Expansion Board 1x 8-Port Expansion Board 1x NC Push Board 1xFlicker Effects Board 1x 5cm Connecting Cable 2x 15cm Connecting Cables...
Page 3
Important things to note: Laying cables in between and underneath bricks Cables can fit in between and underneath LEGO® bricks, plates, and tiles providing they are laid correctly between the LEGO® studs. Do NOT forcefully join LEGO® together around cables; instead ensure they are laying comfortably in between each stud.
Page 4
Incorrectly inserting the connector can can result in bent pins inside the port or possible overheating of the expansion board when connected. Connecting cable connectors to Strip Lights Take extra care when inserting connectors to ports on the Strip Lights. Connectors can be inserted only one way.
Page 5
Connecting Micro Cable connectors to Micro Expansion Board Ports Take extra care when inserting the micro connectors to micro ports of Micro Expansion Boards. Connecting Micro Bit Lights to Micro Expansion Boards is similar to connecting lights and cables to Strip Lights. With the expansion board facing up, ensure the side of the connector with the wires exposed is facing down.
Page 22
Power Bank Note – If your are using the Light My Bricks USB Power Bank, it is normal for the strip light to turn off automatically after a few minutes. This is due to very low power being consumed from the power bank.
Page 44
Note: If you experience any issues with the lights not working and suspect an issue with a component, please try a different port on the expansion board to verify where the fault lies (with the light, expansion board or effects board).
Page 54
Note: If you experience any issues with the lights not working and suspect an issue with a component, please try a different port on the expansion board to verify where the fault lies (with the light, expansion board or effects board).
Page 65
Note: If you experience any issues with the lights not working and suspect an issue with a component, please try a different port on the expansion board to verify where the fault lies (with the light, expansion board or effects board). To correct any issues with expansion board ports, please view the section addressing expansion board issues on our online troubleshooting guide.
Page 68
This finally completes installation of the Light My Bricks Dom’s Dodge Charger Light Kit. We thank you for purchasing this product and hope you ENJOY!
Need help?
Do you have a question about the 42111 and is the answer not in the manual?
Questions and answers