Advertisement
Basic Operation
1
Key Switch ON
(Engine start)
Opening Demo
●The needle will move to the lowest value side several times for searching position. Then it will move to the maximum value and finally to reading for current
measurement item.
Switching The Display and Setting
Peak reading display
1
Press the switch
once
While the meter is in operation, press
the switch once.
2
Peak reading display
LED will light.
3
Real-time display
B a c k t o r e a l - t i m e d i s p l ay a f t e r 3
seconds releasing the switch.
※Each peak value can be reset by the key OFF.
Setting of Warning
※Can't make setting of Warning while displaying Peak reading(LED lighting).
1
Press the switch
for 3 seconds
While the meter is in operation,
press the switch for 3 seconds.
2
Setting warning point display
LED will brink.
Troubleshooting
Trouble
Does not work with Engine start.
Needle of the boost gauge is shifted
to slightly negative from 0 when the
key switch ON and the engine is
stopped.
※Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
※We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar designs, regulating characteristics,
circuitry and circuitry layout.
※We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User' s Manual.
4
2
3
Opening Demo
Reset the Peak reading
1
Press the switch
for 3 seconds
Pressing the switch while displaying the
peak reading will re-set the peak reading.
4
Reset the Peak reading
LED will light off.
5
Real-time display
3
Press
the switch
While holding down
the switch, change the warning setting.
※By continually pressing down on the switch the needle will
move to the maximum point.
Possible Causes
Poor connection of Gauge cable , Link cable ,
6-pin Connector , OBD Connector and IGN cable .
The unit has been installed into an incompatible car
model.
OBD Connector was connected when the key switch
was set to OFF, or car battery was changed.
Depending on the altitude, needle shifts about one scale by the characteristics of car side
sensor(absolute pressure), but this is not a malfunction.
PIVOT CORPORATION
4
Real-time display
Key Switch OFF
(Engine stop)
Measuring the lowest voltage
by voltmeter
1
2
●Recommend to charge or replace the battery if it's lower
about 1V or more than when new.
Each pressing of
t h e s w i t c h w i l l
r a i s e , a t t h e
maximum point it
will return to the
minimum point.
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
5
Meter OFF
ON
ENGINE
Turn the key switch
START
or
ON and display the
STOP
meter
Without braking,
press down twice
START
ENGINE
Start the engine and
START
or
check the lowest
STOP
voltage with Peak
With braking,
reading display
press down once
4
Release
the switch
5
Real-time display
L E D w i l l l i g h t o f f a n d b a c k t o
real-time display after 3 seconds
releasing the switch.
Possible Solutions
Please reconfirm whether wiring and
connections are correct or not.
Please check the "Fitting List" .
Conne c t ag ain OBD Conn ector
when the key switc h is set to ON
(engine start).
Advertisement
