Table of Contents
Advertisement
Quick Links
A
D
A [ mm] D [ mm]
30/55
932
36
1237
1
3
4
!!!DO NOT TURN ON THE DEVICE IN
THE PRESENCE OF HUMANS, ANIMALS AND FLOWERS!!!
Installation can only be carried out by an authorized person and according to the mounting instructions. Any
other installation is considered to be improper. For a good installation and for a device to work properly it is
important to ensure mounting on a at surface. Make sure that the device is always disconnected from the
power supply before the installation. Do not use if the device or the power cable is damaged. Only damp
micro ber cloth can be used for cleaning. Technical changes are subjected without notice. Do not dispose of
the device or its parts as household waste, but recycle it properly.
10-5/A
50
650
650
230V
IP20
50/60Hz
2
L
N
5
max. Ø9-13 mm
0,5-2,5mm
1
Advertisement
Table of Contents
Related Manuals for ELEKTROBOCK CS4-16
Summary of Contents for ELEKTROBOCK CS4-16
- Page 1 230V IP20 50/60Hz A [ mm] D [ mm] 30/55 1237 max. Ø9-13 mm 0,5-2,5mm !!!DO NOT TURN ON THE DEVICE IN THE PRESENCE OF HUMANS, ANIMALS AND FLOWERS!!! Installation can only be carried out by an authorized person and according to the mounting instructions. Any other installation is considered to be improper.
- Page 2 CS4-16 TIME SWITCH The CS4-16 time switch is a device that causes appliances to start and stop working at specific times. If you need to turn on or off an electrical appliance at a specific time, all you have to do is program the CS4-16 time switch in accordance with the instructions below.
- Page 3 The device must not be used for sockets rated at over 16 A. Inductive load switching is possible up to 2 A. Use a dry cloth to clean CS4-16. Only clean the switch once the distribution system has been turned off. Do not leave connected electrical appliances unattended.
Need help?
Do you have a question about the CS4-16 and is the answer not in the manual?
Questions and answers