Electrical And Mechanical Specifications; Electric Connections - Leb Electronics CTR18 Instruction Manual

12) Electrical and mechanical specifications

Dimensions and weight : 177 x 247 x 92 mm - 1,3 Kg
Mains power supply : 230 Vac +/- 10%
Stand-by power consumption : approx. 1 W
Operating temperature range : 0 to + 60 °C
Single-phase motor power supply : 230 Vac 1 HP max
Blinker power supply : 230 Vac 40 W max
Electric lock power supply : 12 Vac 15 W max
Accessories power supply : 24 Vac 6 W max
nd
2 radio channel relay contact : 24 Vac 0,5 A max
Motor's work time : programmable, 0 to 100 sec.
Pause time : programmable, 2 to 100 sec.
Caution : The unit must be not switched on if the connected loads or the power supply exceed the a.m. limits. Failure to observe this precaution can
result in damage to persons, animals or objects for which the manufacturer cannot be held responsible.

13) Electric connections

5 electric connectors are fitted to the card :
1) J5 8-pole Terminal board for the connection of the devices operating with 230 Vac mains power supply (motor, blinker, courtesy light and mains
cable).
2) J6 14-pole Terminal board for the connection of the devices operating at low voltage (commands, safety devices, electric lock and 24 Vac power
supply output)
3) J4 2-pole Terminal board for the connection of the aerial cable
4) J3 4-pole connector for the optional connection of a power regulator card
5) J2 10-pole connector for the optional connection of a radio receiver card
Terminal board J5
Terminal 1 - 230 Vac mains power supply phase
Terminal 2 - 230 Vac mains power supply neutral
Warning: The power supply voltage polarities must be carefully observed.
Terminal 3 - 230 Vac blinker power supply phase
Terminal 4 - 230 Vac blinker and courtesy light power supply neutral
Terminal 5 - 230 Vac electrochain or courtesy light power supply phase
Terminal 6 - 230 Vac motor M1 power supply phase (opening)
Terminal 7 - 230 Vac motor M1 power supply phase (closure)
Terminal 8 - 230 Vac motor M1 Power supply common
Note: connect the capacitor of the motor M1 between terminals 6 and 7
25
ENGLISH