Use Casea - 2 Node Configuration - Ntb Mode; Connecting The Cables For 2 Node Configurations, X16 Link - Dolphin MXH94 Series User Manual

NTB Use Cases Summary and DIP Settings
The adapter card may be used in the following NTB use cases. Please contact Dolphin if you have other requirements for BAR size.
Use Description
case
A Two node NTB configuration. Both
systems have a similar adapter card
installed.
Use Case A - 2 Node Configuration – NTB Mode
Each node has an NTB enabled adapter card and a direct cable connection to the other system. This configuration is fully supported
by all Dolphin software, from version DIS 5.18.0 and newer. Both adapter cards operate in NTB mode. Dip switches should be set as
specified in Table 2: DIP Switch settings on page 10.

Connecting the cables for 2 Node Configurations, x16 link

To establish an x16 link, a given port number should be connected to the same port number on the other card.
MXH94x / MXH95x NTB Adapter User's Guide – Dolphin Interconnect Solutions
BAR SIZE
256 Megabytes
32 Gigabytes
Table 3: Use Case DIP switch settings
DIP switch setting
OPT4: ON
Opt4: ON
OPT1: ON
Page 11