Advertisement
Table of Contents
E-BEEP2-x
Miniature Piezo Buzzer, PCB Mount, 95dB
Guide for Installation with an ENVIROMUX
Enterprise Environment Monitoring System
E-BEEP2-x is a general purpose piezo buzzer to provide audible indication of alert when configured to respond to variations in a
sensor's readings. Operating on 12VDC, the E-BEEP2-x can be controlled and powered by an E-2D, E-5D or E-16D Enterprise
Environment Monitoring System (SYSTEM). With an optional 12VDC power supply, the E-BEEP2 can also be controlled by an
E-MINI-LXO. A 22AWG 2-wire cable (x) is pre-soldered to the leads and available in lengths of
1/10/50/100/200/400/600/800/1000 feet.
Follow the wiring diagrams below to connect the E-BEEP2-x to a SYSTEM and then configure the SYSTEM to power the piezo as
part of an alert response to provide users with audible indication of alert. An example of that configuration can be found on page
2.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for NTI E-BEEP2 Series
Summary of Contents for NTI E-BEEP2 Series
- Page 1 E-BEEP2-x Miniature Piezo Buzzer, PCB Mount, 95dB Guide for Installation with an ENVIROMUX Enterprise Environment Monitoring System E-BEEP2-x is a general purpose piezo buzzer to provide audible indication of alert when configured to respond to variations in a sensor’s readings. Operating on 12VDC, the E-BEEP2-x can be controlled and powered by an E-2D, E-5D or E-16D Enterprise Environment Monitoring System (SYSTEM).
- Page 2 For the E-16D, on sensor configuration page, place a checkmark in the “Enable Siren” box for any sensor that should activate the piezo when it causes the ENVIROMUX to send an alert. Figure 1- Sensor configuration page from E-16D For the E-2D,E-5D, or E-MINI-LXO, on sensor configuration page, make sure the associated output relay isn’t “none”...
- Page 3 Specifications Mounting PCB Mount- 7.62 mm centers (without pre-attached leads) Operating Mode Continuous sound at 4KHz Operating Voltage 1-12 Vdc Typical Operating Current 20 mA at 12 Vdc 85 dB(A), at 5 Vdc Typical Sound Pressure 95 dB(A), at 15 Vdc Solder terminals (long lead is positive)- 2-wire cable pre-attached (white wire Termination is positive)
Need help?
Do you have a question about the E-BEEP2 Series and is the answer not in the manual?
Questions and answers