Morphy Richards 720512 Instruction Book page 7

VC720512MUK Rev1.qxp_Instruction Book 15/04/2020 10:40 Page 7
Using in upright steam cleaning mode (continued)
Place the floorhead
floorhead to the floor with your foot and tilt the
main body (7) back, releasing the floorhead
from the floorhead rest catch (13).
Slowly push the cleaner back and forth along
the floor.
Using the handheld steam cleaner
This function is ideal for cleaning vertical
surfaces and hard to reach places.
Separate the handheld steam cleaner
the main body (7)
release button (3)
Pull the handheld steam cleaner up and out of
the main body.
In order to use all of the accessories (excluding
the utility nozzle
(29)), the accessory adaptor
attached onto the handheld steam cleaner (8).
This can be done by completing the following:
Slide the adaptor into the nozzle of the handheld
steam cleaner with the release catch on the
underside of the nozzle in line with the square
hole on the adaptor.
Push together and fix into place.
B
Attach the desired accessory to the end of the
adaptor by aligning the raised circular sections
on the adaptor with the gaps on the accessory
(ensure the same-sized gaps and circular
sections align with each other).
(17) on the floor. Hold the
(8) from
by pressing the handheld
on the front of the main body.
(28) and squeegee attachment
(25) must firstly be
5
If cleaning carpet, rest the floorhead
the micro-fibre floor cloth
carpet glider (19) to make it easier to move the
floorhead across the carpet.
NOTE: The carpet glider has clips around the
edge to attach it securely to the floorhead.
A
25
Twist the accessory until the arrow on the
adaptor aligns with the arrow on the accessory.
NOTE: handheld mode has been designed for
one-handed use.
Warning
WARNING: Switch OFF and unplug before
changing nozzles. After use, nozzles will be
very hot. Allow to cool before handling.
WARNING: When using in the handheld mode,
only ever hold the product by the handheld
handle (6).
The underside of the handheld steam cleaner
(8) will become warm during use - this is
normal. Never place the product on delicate
surfaces that could be affected by heat.
Never block any nozzle, eg. by holding against a
surface being cleaned.
6
(17) with
(18) attached into the
B
7 7