Taurus Alpatec PLEASANT Manual page 17

ANOMALIES AND REPAIR
- If any anomaly is detected, check the following
table:
Anomalies
The unit doesn't operate.
The dehumidifying
function doesn't work
No air is discharged
Operation is noisy
The appliance contains flammable refrigerant
Possible Cause
Has the power cord been
disconnected?
Is the tank full indication
lamp blinking? (The tank is
full or in a wrong position.)
Is the temperature of the
room above 35ºC or below
5ºC?
Is the air filter clogged?
Is the intake duct or
discharge duct obstructed?
Is the air filter clogged?
Is the unit tilted or
unsteady?
Is the air filter clogged?
Solution
Plug the power cord into the outlet.
Empty the water in the drainage tank
and then reposition the tank.
The protection device is
activated and the unit
cannot be started.
Clean the air filter as
instructed under the section
"Cleaning the air filter".
Remove the obstruction from the
discharge duct or intake duct.
Clean the air filter as
instructed under the section
"Cleaning the air filter".
Move the unit to a stable, sturdy
location.
Clean the air filter as
instructed under the section
"Cleaning the air filter".