Advertisement
4.2.
WB952LED.V2: Three Bolt Fixing Base
4.2.1.
Drill mounting holes using the beacon base as a template. Also make provision to route cables into the vehicle.
4.2.2.
Connect to cables of at least 2mm² section and use an 8A fuse; check polarities.
4.2.3.
Fix the beacon with 3 x M6 screws.
4.3.
WB954LED.V2: Magnetic Base
4.3.1.
Fitted with high power magnet strong enough to cope with normal road speeds.
4.3.2.
Supplied with 3m coiled flex and universal auxiliary power outlet plug.
4.3.3.
The beacon must be placed on a surface parallel to the ground.
4.3.4.
The surface should be flat and clean to ensure good adherence.
4.4.
WB955LED.V2: Flexible Base with DIN Spigot Mounting.
4.4.1.
Fit a suitable adapter socket onto the vehicle. Make sure it is perfectly vertical.
4.4.2.
Use cables of at least 2mm² section and use an 8A fuse; check polarities.
4.4.3.
Push the beacon spigot down fully onto the adapter socket and secure by tightening the wing nut.
4.4.4.
When the beacon is removed, always close the adapter socket outlet using the rubber cap.
5. FLASH PATTERN SELECTION
5.1.
Three flash patterns are available for selection using button on the top of the unit as in fig.2. The button is accessed by removing
the dome as in fig.1.
5.2.
Pattern 1: Rotating flash; flash rotates mimicking a rotary beacon.
Pattern 2: Rapid flashes.
Pattern 3: Three rapid flashes followed by a break.
NOTE: When switched on the unit will display as the last pattern setting.
fig.1
6. VOLTAGE SELECTION
6.1.
The beacons will switch between 12V and 24V automatically.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
Original Language Version
© Jack Sealey Limited
Pattern
Selector
fig.2
01284 703534
sales@sealey.co.uk
WB951LED.V2, WB952LED.V2, WB954LED.V2, WB955LED.V2 Issue 1 14/12/20
www.sealey.co.uk
Advertisement
