Important Information - Siemens SiPass AC5160 Installation Instructions Manual

Important Information

4
Siemens Building Technologies
Fire & Security Products
Only authorized personnel may assemble and install the system.
Your attention is drawn to the fact that the contents of these Installation Instructions are not part of a
previous or existing agreement, commitment or statutory right and do not change these. All
commitments on the part of Siemens are contained in the respective sales contract which also
contains the complete and solely applicable warranty conditions. These warranty conditions in the
contract are neither extended nor limited by the contents of this Manual. Should you require any
further information, or should particular problems occur that are not handled in sufficient depth in these
Installations Instructions, help can be requested through your local Siemens office or representative.
Please read and comply with the following notes before assembling and installing
the unit:
Please ensure that the controller is installed in a clean room. Please ensure that
the central control unit is protected from damaging environmental influences
such as direct sun exposure, operation-dependent vibrations, dust, etc.
Never install the controller close to heaters and sinks. Avoid the proximity of
sources of electrical or mechanical interferences. If the controller is installed in
an enclosed space such as behind paneling or in small niches, please ensure
sufficient ventilation. Please use electrically conducting floor coverings to
minimize electrostatic charges.
The permissible ambient temperature of the central control unit must be between
-10 and +55 °C, humidity should not exceed 75% if possible (95% for very short
periods, no condensation).
Use a separate electrical circuit with a specially marked fuse ("red") to supply
a.c. voltage to the unit.
Please ensure that switching off other tools or devices does not disconnect the
electrical circuit to the unit. Attach a note in the cabinet about the location of the
power supply fuse (low-voltage distributor number / mains fuse number). Please
ensure that the fuse is easy to access.
Please ensure that the cable duct covers the cable entry opening.
Use only shielded cables with extra-low voltage for all lines leading to the inside
of the controller. Connect the cable shielding to all connection points. Ground
cable shielding only on one side.
The precautions applicable for C-MOS technology are to be applied to activities
involving server circuit boards and soldering.
Never install a live circuit board.
A24205-A335-B219.doc
08.2004