Advertisement
After wall covering
6.1. The wall box is cut down to approximately
2 mm from the completed wall with LK Wall Box
Cutter UNI (Article no. 187 64 94).
If the wall cladding is to have a vinyl covering
then the LK Wall Box Cutter UNI UTV (Article
no. 188 21 54) can be used.
LK Connection couplings
7.1.1 For assembly of tap mixer in accordance with
Swedish standards, LK Connection coupling M26
(Article no. 188 18 45) should be assembled. The
length of the connection should be adjusted and
the thread joint against the angle fitting should be
sealed with, for example, flax and thread paste.
Tightening is done with a combination wrench or
a 14 mm Allen key.
NOTE!
Thread tape should not be used on the con-
nection coupling.
8 (8)
Assembly instructions | LK Wallbox UNI Push AX16 V2 and AX20
LK Systems AB, Box 66, 161 26 Bromma, Sweden | www.lksystems.se/en
7.1.2 For assembly of tap mixer in accordance with
international standards, LK Connection coupling
¾"/ ½" (Article no. 188 18 48) should be assembled.
The length of the connection coupling should be
adjusted so that approximately 10 mm of the ¾"
pipe thread is exposed when the cover plate is tigh-
tened against the wall. The thread joint against the
angle fitting should be sealed with, for example,
flax and thread paste. Thread tape should not be
used. Tightening is done with a 14 mm Allen key.
NOTE!
Thread tape should not be used on the con-
nection coupling.
For more variants of connection couplings, visit:
https://www.lksystems.se/en/products/lk-uni-
versal/products/installation-components/angle-
wall-box-mounting/connection-couplings/
Replacement of PE-X pipe to
LK Wallbox Push
For replacement of LK PE-X Universal Pipe X,
refer to assembly instructions for LK PEX, PAL
and PE-RT.
Accessories for LK Wallbox UNI Push
Reinforcement for Wallbox
LK Reinforcement for Wallbox UNI (Article no.
188 10 66), see picture below, is used when the
mixer needs maximum support. The reinforcement
has a female ½" thread which is screwed onto a
connection coupling. The connection coupling is
then threaded on the wallbox angle fitting.
EN.29.C.46.20200318
Advertisement
