Frigidaire FLCE752CAW0 Use & Care Manual page 50

50
TROUBLESHOOTING
Before Calling (continued)
PROBLEM POSSIBLE CAUSES
Water does • Washer lid is open.
not enter
washer or it
• Water supply is not adequate
enters slowly in area.
• Water supply faucets are not
completely open.
• Water is being used elsewhere
in the house.
• Water inlet hoses are kinked.
Warm or hot • Hot water heater is set too
low or is a distance from
water is not
washer.
hot enough
• Hot water is being used
elsewhere in the house.
Water in • Drain hose is kinked or
clogged.
washer does
not drain or
drains slowly
Water leaks • Loose fill hose connection at
faucet or washer.
• House drain pipes are
clogged.
Incorrect • Hot and cold water hoses are
connected to wrong supply
wash
faucets.
and rinse
temperatures
Water is • Drain hose standpipe is
incorrect height.
entering
washer but
tub does not
fill
Water is • Lid lock malfunction.
present in
tub after
wash cycle is
complete
The drain • Lid lock malfunction.
and spin
cycles did
not occur
SOLUTIONS
• Close washer lid. The washer will
not operate when the lid is open.
• Check another faucet in the
house. Wait until water supply and
pressure increase.
• Fully open hot and cold faucets.
• Water pressure must be at least 10
psi (69 kPa). Avoid running water
elsewhere while washer is filling.
• Straighten hoses.
• Measure hot water temperature at
nearby faucet with candy or meat
thermometer. Water temperature
should be at least 120°F (50°C).
Adjust water heater as necessary.
• Avoid using hot water elsewhere
before or during washer use. There
may not be enough hot water
available for proper cleaning. If
problem persists, your hot water
system may be unable to support
more than 1 use at a time.
• Clean and straighten the drain
hose.
• Check and tighten hose
connections. Install rubber sealing
washers provided.
• Unclog drain pipes. Contact
plumber if necessary.
• Connect hot water hose to hot
water faucet and cold water hose
to cold water faucet.
• Standpipe must be a minimum
of 33" (84 cm) high to prevent
siphoning. See Installation section.
• DO NOT bypass lid lock. Call your
authorized service provider.
• DO NOT bypass lid lock. Call your
authorized service provider.