Download Print this page

Lacont CHS Operating Manual page 11

Chemical cabinets

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 9
5.
Transport
The storeLAB
chemical cabinets must only be picked up from the bottom side using suitable
®
transporting equipment and must be transported vertically. Tilting when picking up and
transporting must be avoided in all cases.
Always pick up the cabinet from the side or from the rear. Never pick up from the door side.
The pick up area of the barrow, forklift or similar must have at least the same floor space of the
safety cabinet.
6.
Setting up
The ground must be level and be able to bear the weight of the storeLAB® chemical cabinet
when fully loaded.
The storeLAB
chemical cabinet must be setup horizontally and any safety equipment must be
®
installed (e.g. wall holder with CHS-APO). This is the only way to ensure that the cabinet does
not fall over.
The position of the actual location of use / operation must ensure that the chemical cabinet:
- cannot be damaged by vehicles,
- is not exposed to any sources of direct or indirect heat,
- is protected against moisture.
Suitable personal protective equipment must be worn when using substances or toxins harmful
to health!
The location of the exhaust connections can be obtained in Appendix 1 (see sketches)
7.
Commissioning
The chemical cabinet must be setup, operated and maintained in such a way that the safety of
the employees is guaranteed.
With CHS-APO see assembling instructions (inside the cabinet door)
Suitable personal protective equipment must be worn when using substances or toxins
harmful to health!
8.
Interior installations
8.1
Tray insert
The supplied tray insert as well as the floor support are installed in the cabinet ex-factory.
For positioning the tray insert, lift the tray insert and pull horizontally from the cabinet. Pull the
floor supports out of the bottom holes of the positioning strip and turn 90° upwards. Now pull
the floor support standing horizontally from the top holes of the positioning strip. The assembly
in the new position is carried out in the reverse order of the procedure previously described.
11

Advertisement

loading