Dyna-Glo DGP552SSP Manual page 12

ASSEMBLY INSTRUCTIONS
11. Carefully place the grill body (C) onto cart
left side panel assembly (P) and cart right
side panel assembly (L). Adjust the grill body
(C) so that the holes in the grill body (C) are
aligned with holes in the tabs of cart left side
panel assembly (P) and cart right side panel
assembly (L).
Note: Make sure the gas hose/regulator
assembly is outside the cart. Secure the grill
body (C) with four M6X16 bolts (AA).
Hardware Used
AA M6x16 Bolt
12. Insert two M6x16 bolts (AA) in left side of grill
body (C) as shown, leaving 5mm of threads
exposed. Align key hole in left side table
assembly (V) with the two bolts just inserted
in the grill body (C), and insert two M6x16
bolts (AA) in the remaining holes in the grill
body (C). Adjust left side table assembly (V)
correctly, then tighten all bolts.
Hardware Used
AA M6x16 Bolt
11
x 4
12
V
V
x 4
12
C
C
AA
L
C
AA
AA