Table of Contents
Advertisement
NOTE:
The 24 Vac relay module is not
applicable for smoke control
application.
Regulatory
FCC Statement Part 15.19
This Device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference
received, including interference that may cause
undesired operation
FCC Part 15.21, Information to user
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Part 15.105, Information to user
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
Siemens Industry, Inc.
Wiring Diagrams
Offboard Air Module Wiring.
CAUTION
The FHC-OAVS has two terminal
blocks with terminations numbered
identically (terminations 1 through
16). DO NOT get these mixed up
with each other.
If the FHC-OAVS is not connected
as shown, it is not resistant to
electrical surges. It is also
susceptible to interference from
other equipment.
Le LCM-OAVS est muni de deux
bornes dont les contacts sont
numérotés à l'identique (contacts 1
à 16). NE PAS les confondre.
SI le LCM-OAVS n'est pas
connecté comme indiqué, il n'est
pas protégé contre les surtensions
électriques. Il est également
susceptible à des interférences
émises par d'autres périphériques.
Document No. 570-136
Installation Instructions
October 26, 2016
ATTENTION
Page 5 of 11
Advertisement
Table of Contents
