Advertisement
Quick Links
NEED INSTALLATION OR SETUP ASSISTANCE?
Or visit www.RelianceDetection.com/support/RSC-900
RSC-900 Wireless System FCC & Industry Canada Information
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Certifications:
FCC
Flood Sensor RSC-900-W-001 2AFOICLMFLD10
Hub RSC-900-X-650
2AFOICLMCTRL10
Hub RSC-900-X-800
2AFOICLMCTRL10
Actuator RSC-900-W-310
2AFOICLMASOU20
Communication hub: IP Rating IEC60529
Valve/actuator: IP Rating IEC60529; IP68, ANSI61, Annex G (valve)
RSC-900 leak detection systems with shut-off valves
should be installed by an authorized plumber. Hub and
sensors are for interior use only. The valve/actuator may be
installed on the exterior of the building, if necessary and as the local
climate allows. When considering exterior installation, be sure the
actuator would not be immersed in water for more than 30 minutes and
immersed in water deeper than 3'. Do not install any components inside
a metal cabinet.
RSC-900 Series
Quick-Start Guide
Call toll-free: 888-771-4929
IC
20798-CLMFLD10
20798-CLMCTRL10
20798-CLMCTRL10
20798-CLMASOU20
RSC-900 System Components
(included in all kits):
1 – Communication hub
(Ethernet or Wi-Fi)
2 – AA batteries (hub)
1 – Ethernet cable
(Ethernet models only)
1 – 110V plug (hub)
2 – Water flood sensors
4 – AAA batteries (sensors)
RSC-900-AW kits:
1 – Valve
1 – Actuator
4 – CR123A (3V) batteries
(actuator)
1 – Long parallel mounting
adaptor (valve/actuator)
1 – Short perpendicular
mounting adaptor
(valve/actuator)
1 – Emergency key
(valve/actuator)
Advertisement
Summary of Contents for RDT RSC-900 Series
- Page 1 RSC-900 Series Quick-Start Guide NEED INSTALLATION OR SETUP ASSISTANCE? Call toll-free: 888-771-4929 Or visit www.RelianceDetection.com/support/RSC-900 RSC-900 Wireless System FCC & Industry Canada Information RSC-900 System Components (included in all kits): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful 1 –...
- Page 2 Download the RSC-900 System Management App Download the “RSC-900 by RDT” app onto the designated smartphone from the Apple App Store or Google Play. Set Up the Communication Hub FOR WI-FI HUB SYSTEMS: You will be registering the RSC-900 to your designated Wi-Fi network;...
- Page 3 Set Up the Valve and Actuator (Skip to step 5 if your install does not include water shut-off) Install the CR123A (3V) batteries with positive side “in” and negative side “out,” facing you. Install the stem and adaptor as shown, using the provided screws.
- Page 4 Set Up the Master Kit Slide to open Water Flood Sensors Install AAA batteries. Record the sensor name and location in the app (confirm the correct device via the unique serial number on the app and sensor QR code). Repeat for each sensor. Place the sensors in their desired locations.