Advertisement
Set Up the Master Kit
5
Water Flood Sensors
1 -
Install AAA batteries.
2 -
Record the sensor name and
location in the app (confirm the
correct device via the unique serial
number on the app and sensor QR code).
3 -
Repeat for each sensor.
4 -
Place the sensors in their desired locations.
A.
LED status light
B.
Water detection electrodes
Adding Accessory Sensors & Actuators
6
1 -
Install the new device in its permanent
location.
2 -
From the App, tap on Menu – Settings – Add/
Remove Devices – Configure – Add Devices.
Scan the device QR code (see right).
Confirm Set Up
7
Once all devices have been deployed, confirm your
system is properly set up and devices are within
wireless signal range of the Hub.
1 -
From the RSC-900 app menu in the upper-left corner
of the screen (see icon at right), click on "Settings."
2 -
Tap "Add/Remove Devices."
3 -
Tap "Configure" next to the appropriate system
(if you have multiple systems).
4 -
Tap "Accept" at the bottom of the screen. The
system will now confirm wireless signal strength of
all devices. Devices will be momentarily greyed out
on the screen while this occurs.
5 -
Observe the devices come back on-line (borders
around all device icons), along with their "Wireless
Signal" strength indication.
6 -
Look for any warning symbols along the right-hand
side of the screen.
repeater is needed for indicated device(s). Follow
installation instructions for RSC-900-X-200 Wireless
Signal Repeater to overcome wireless signal issues.
© Copyright 2021 Reliance Detection Technologies, LLC – A Madison Company – All specifications subject to change without notice.
Slide to open
C
D
C.
Battery housing cover
D.
Double-sided tape
indicates that the use of a
Reliance Detection Technologies, LLC
27 Business Park Drive
Branford, CT 06405
ECN # 12003, 01/2021, MF165, REV F
3 -
Tap the new device on the
app screen.
4 -
Scroll down and tap "Edit."
5 -
Add name, location, and photo of installation
location (optional).
Test the System
8
1 -
Apply a wet paper towel to a
sensor's electrodes until its
LED flashes red and its alarm/
beep sounds.
2 -
A "Leak!" indicator message will
appear on the home screen of
the app.
3 -
If you have a valve and actuator
shut-off installed, confirm that
there is no water flow.
In the app, tap the water shut-off
icon, and then tap "Open" on the
screen to open the valve. Verify
that water is flowing at the faucet.
5 -
Repeat for each sensor in
the system.
203-488-2684 or 888-771-4929
info@RelianceDetection.com
www.RelianceDetection.com
A
B
Advertisement
