Sony ECM-W2BT Help Manual page 17

Table of Contents

When the audio output that is not supported by your camera is selected by the slide switch on the receiver, a cautionary message

may appear on the camera's finder screen. In such a case, select the supported audio output.

While recording is in progress, changing the receiver mode with the mode switch may cause a failure in switching the receiver

mode, a failure in audio recording due to disconnected communication, or noise in a recording. Before selecting a receiver mode

with the mode switch, be sure to stop the recording.

While recording is in progress, changing the audio recording volume with the ATT switch may cause operation sounds of the

switch to be recorded. Before selecting an audio recording volume with the ATT switch, be sure to stop the recording.

To avoid the possibility of the confirmation beep (Audio signals) at the start of a recording being picked up by this unit, it is

recommended that you set [Audio signals] to [Off] on your camera. For further details, refer to the operating instructions of your

camera.

When using this unit in the MIX mode, if the receiver and microphone pick up the same sound, it causes an echo or clipping

noise. Place the microphone farther away from the receiver not to pick up the same sound.

When using this unit in the MIX mode, if the power of the microphone turns off or the receiver and microphone are not connected

when you start recording, noise or no sound may be recorded. Ensure that the LINK lamps of the receiver and microphone are lit

in blue and connection is established, and then start recording.

The receiver receives power supply from the camera as well. Depending on your camera, however, it may not be capable of

supplying power. For the camera models that support power supply to the receiver, visit our website at:

https://www.sony.net/dics/w2bt/