Sony ECM-W2BT Help Manual page 16

Help Guide
Wireless Microphone
ECM-W2BT
Recording
Use the receiver attached to a camera and the microphone attached to the subject's clothing for recording sound.
Turn on the power of the camera and set it in standby mode.
1
Turn on the receiver and the microphone.
2
Select your desired audio output with the slide switch (MIC OUT ANALOG/Power OFF/DIGITAL) on the receiver.
Select "ON" with the power switch on the microphone.
Immediately after both the receiver and the microphone are turned on, the LINK lamps on both devices start
blinking slowly in blue. This indicates that each of the devices is making a series of attempts to detect, connect to,
and authenticate the other device. When a communication connection is established between the devices and clear
audio recording is available, the LINK lamps on both devices stop blinking and stay lit in blue.
If no connection is established, bring the microphone and the receiver closer to each other for another attempt. The
devices may be under influence of environmental or other factors.
Ensure that the LINK lamp on the receiver is lit, and press the record start button on the camera.
3
Note
Depending on your camera, the "DIGITAL" audio output may not be supported. For the camera models that support the
"DIGITAL" audio output, visit our website at:
https://www.sony.net/dics/w2bt/
16