Operation - TECHWOOD TBLI-1500 Instruction Manual

7. Switch speed control knob to the low level 1 for 5-10 seconds.
8. Turn the speed control to the max speed and allow the blender to run for 30
seconds.
9. Rinse all parts thoroughly and allow them to dry completely.
Warning: Do not put hands or other objects into the jar while the blender is
operating; doing so may result in serious injury and may damage the blender.
 Connect the plug with the power, the unit with the blue light flash one time.
 Then turn the knob clockwise one level, the unit comes into the standby
mode.
 Under the standby mode, you can do below operations:
1. Choose any one button from the 3 preset buttons on the left side, then the
chosen preset program will work automatically, after finish, it will stop and
back into the standby mode. If need to stop the working process, press the
selected button again.
2. Do not choose any preset buttons, directly turn the speed knob from min to
max to blend. The variable speed control makes your blending optionally.
Once finish blending, turn back the knob to "o", then it comes back to
standby mode.
3. Press the middle circle on the control knob to reach the pulse function any
time. Once the finger loose from the knob, it goes back to standby mode.
 Once the preset button is chosen, during its working time, the speed knob
can not work.
 Once the speed knob is working in the blending process, the preset buttons
can not work.
 During all the working process, the related blue light is on.
 To stop the working process,

OPERATION

9