TECHWOOD TBLI-1500 Instruction Manual page 8

 Unroll the power cord completely.
 Check that the tension in force in the country where you are, corresponds to
that indicated on the apparatus.
 Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
 Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
 Never modify the appliance in anyway.
Knob
Function buttons
On/off
Blending
To extend product lifetime, it is recommended to run the blender for no more than
2 minutes when blending on the high speed, then the blender should cool for at
least one minute to avoid overheating.
After 2 cycles, Allow the blender to rest for at least 10 minutes before reuse.
1. Fill the jar halfway with warm, soapy water (be careful when washing
inside the jar as the blades are very sharp). Do not immerse the motor
unit in water or any other liquid.
2. Wipe the motor unit with a slightly dampened soft cloth.
3. Hold the jar by the handle, and lower it onto the motor.
4. Twist the jar clockwise until it locates and locks on the motor unit.
Important: The motor unit will not work unless the jar is correctly fitted.
5. Place the lid on top of the jar and press down until the lid sits on the rim of
the jar.
6. Refit the filler cap back in the lid, ensuring the small projection on both sides
of the filler cap locate in the slots in the lid, and turn filler cap anti-clockwise
until tight.
FUNCTION
Manually Operation, middle circle is Pulse function
Include Ice crush (Glace pilée), Auto clean (Auto Nettoyant),
Smoothie
"0" is the off state.
The blender is with variable speed control by showing min to max
marks around the knob.
USE
8