Table of Contents
Advertisement
1.6.1
Installing a SIMM
Observe the ESD precautions when installing
components. See section 1.2.
Follow these steps to install a SIMM:
1.
Carefully slip a SIMM at a 45 angle into a socket making sure
that the curved edge indicating the pin 1 of the SIMM matches
pin 1 of the socket.
A SIMM fits only in one direction. If you slip
in a SIMM but would not completely fit, you
may have inserted it the wrong way. Reverse
the orientation of the SIMM.
2.
Gently push the SIMM to a vertical position until the pegs of the
socket slip into the holes on the SIMM, and the holding clips lock
the SIMM into position. The SIMM should be at a 90 angle when
installed.
Figure 1-5
Installing a SIMM
1-14
1
2
Pin 1 Indicator
(curved edge)
Peg
Hole
User's Guide
Advertisement
Table of Contents
