Advertisement
3. Centre the front grid; aligning the logo, it must be horizontal and parallel to
the ground.
4. Secure Front & Rear grids tightening the fixing clips.
Make sure the clips are firmly in place.
5. Tighten the locking screw at the bottom of the back gate.
1. Position the bottom of the U-shaped fan on the top of the base & insert pin in
the first part of the U and in the tube and finally the other part of the U.
2. Screw the clamping screw.
● Unroll the power cord completely.
● Check that the tension in force in the country where you are corresponds to
that indicated on the apparatus.
● Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
● Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
● Never modify the appliance in anyway.
• Always unplug the appliance and let it cool before cleaning.
• Clean the outside of the appliance with a sponge or damp cloth.
• Never immerse the appliance in water or other liquids!
• Never use abrasives, wire brush or other sharp object.
• The front and rear gates can be cleaned with a brush or a soft, damp cloth.
FAN – BASE ASSEMBLY METHOD
CLEANING AND MAINTENANCE
USE
2
Advertisement
