Automatic Programming - TECHWOOD TCA-1518i Instruction Manual

Place the permanent filter (or paper filter) in the filter holder.
While the machine is preheating, pour coffee powder into the filter and pack the
coffee slightly.
Insert the assembly into the device and close the tank lid.
Press the On / Off switch. => the red indicator light comes on and the unit starts to
heat up. Water flows into the filter holder and coffee into the jug.
When the water has run out, press the On / Off switch again to stop the unit.
Notes : The unit can be stopped at any time by pressing the On / Off switch.
Do not open the tank lid while the coffee is flowing.
If the machine is not shut down, the coffee can be kept warm for 30
minutes on the hotplate. After this time, the coffee maker will stop
automatically.
Note : The time display is 24 hours.
1. Press the "PROG" (program) key. The blue pilot light corresponding to the clock
setting lights up.
2. Press the 'HR' button and then the 'MIN' button to set the current time.
Note : Press 'HR' and 'MIN' keys several times to scroll and adapt the time.
3. Press the "PROG" key again. to set the starting time, The blue pilot light,
corresponding to the setting starting time, lights up.
Notes : Set also the starting time with 'HR' and 'MIN' buttons.
When the setting is complete, the machine automatically exits setting after
15 seconds and the lights are off.
4. To activate the programme, press the "program (PROG)" button again. The
blue pilot light indicates that the program mode is activated.
5. The coffee-maker will start automatically at the chosen time. When the coffee-
maker starts, the blue indicator light turns off and the red indicator lights to
indicate that the coffee machine is running.
After the coffee has run out, if the appliance is not turned off, the coffee can be
kept warm for 30 minutes on the hotplate. After this time, the coffee-maker will
stop automatically.
Note : It is, at any time, possible to stop programming by pressing the "PROG"
key again. The blue LED will light off.
If you need to start the appliance immediately, Press the M/A switch and in this
case, the red light will light on again and the coffee-maker will run out.
Note: To change the starting time programming, press the "PROG" key three
times in a row. The previous time will be erased and you will have to reprogram a
starting time. (To see above).
USE
MAKE COFFEE IMMEDIATELY

AUTOMATIC PROGRAMMING.

8