First Use - TECHWOOD TCA-1518i Instruction Manual

1. Water flow system
2. Water tank lid
3. Water level visualization window
4. Water tank
5. Hot plate
6. Spoon / doser
7. Anti-slip feet
8. Jug
9. Anti-drip system
10. Control panel
11. Lid closure
12. Filter holder
13. Permanent filter
Before first use, remove the device and all accessories gently.
• Clean all accessories and bowls with soapy water and dry thoroughly. In
accordance with the instructions in the section "Cleaning and maintenance".
• Place the machine on a suitable flat and stable surface.
• Unwind the power cord completely.
• Check that the voltage in the country where you are, corresponds to the voltage
indicated on the device.
• Plug the unit into a good electrical outlet, (earthed if the device is class I), to
avoid any danger.
• Disconnect the power cable from the mains before any maintenance cleaning
and accessory fitting operation.
• Never modify the device.
Before making the first cup of coffee, it is best to rinse the machine with clean
water.
1. Open the tank lid.
2. Pour water into the water tank.
Note: The water level must not exceed the "MAX" mark on the tank.
3. Close the lid of the water tank.
4. Place the carafe under the filter holder.
5. Connect the device to the mains. The unit beeps and the display shows "12:00"
6. Press the On / Off switch. => the red indicator light comes on and the unit starts
to heat up. Water flows into the filter holder and into the carafe.
7. When the water has run out, press the On / Off switch again to stop the unit.
8. Empty the jug into the sink. The machine is ready.
TO KNOW ITS UNIT

FIRST USE

DO NOT PUT COFFE IN THE FILTER
7