Advertisement
A. Arca Compatible #C60 Clamp with Spirit Level
C. Locking Knob
#HM1, Tilt Head Mounting and Functionality
Mount the #HM1 onto your Monopod in 1 of 3 ways.
1.
Screw your Monopod with a 3/8-16 screw into the bottom center of the #HM1
Monopod Tilt Head Base (G). Tighten until snug.
2.
Screw your Monopod with a 1/4-20 screw into the bottom of either of the (2)
mounting positions available on the #HM1 Monopod Base (G). Tighten until snug.
3.
Lock the #HM1 Tilt Head onto an Arca Compatible Clamp using the Arca
Compatible Mounting Base (F).
Holding your camera and lens securely, mount your favorite Arca Compatible Lens
Plate into the #C60 Clamp (A) and tighten. For cameras without a lens plate we
suggest the ProMediaGear #PXC2 8" Rail with Clamp, sold separately. This will
allow you to mount to an Arca Compatible Plate on your camera and create a rail
under your lens that will allow proper positioning on the #HM1 Tilt Head. Never let
go of your camera and lens until everything is secured and tightened.
Adjust the Friction Knob (D) and the Locking Knob (C) to allow your #HM1 Tilt
Head to move freely. With the Locking Knob (C) loose, slowly tighten the Friction
Knob (D) and dial in your favorite shooting position. Next, tighten the Locking
Knob (C) for fine adjustments and / or to lock the #HM1 in place.
Instructions
G. 3/8-16 Threaded Mounting Adapter
(2) 1/4-20 Threaded Mounting Adapters
B. Clamp Lock Knob
D. Friction Knob
E. Pivot Point
F. Arca Compatible Base
Advertisement
