GreenBrook DW081A-C Manual

Security Window Sensor
• Wireless Magnetic Sensor
(Door/Window Alert)
• For use with wireless Doorchimes
• 433MHz, 16 code settings
• Up to 50M range
• 2x "AAA" Batteries
• Indoor use only
• CE - EMC / LVD / R&TTE approved
• RoHS compliance
1. Open the cover of the Magnetic
sensor with a flat screwdriver. A
gentle twisting will remove the
cover of the sensor.
2. Insert two size "AAA" alkaline
batteries in the sensor, observ-
ing the polarity.
3. Set the house codes (1-16)
inside the sensor, it must be
matching with the code set in
the receiver.
4. Set 3 position slide switch to
selected tune (see diagram 2)
Note: different sensors can all
be set to different tunes if
required.
5. There is a test switch at the
back for testing with receiver
before mounting.
6. Locate the sensor and the
magnetic piece (see dia 1) on
the opening such as door or
window. Do not mount the
sensor on a metal surface.
7. Mount the back plate on a
desired area with the 2 screws
supplied. Select a mounting
location no further than 50m
from the receiver, actual
working range depends on the
number of walls that the signal
has to pass through.
8. Place the back plate in the right
position, drill two 4.76mm
holes and insert the wall plugs,
then tighten the plate on to the
wall with the screws (dia. 2.6 x
26mm) supplied.
9. Position the sensor over the
back plate so that the lip on the
back plate engages into the slot.
DW081A-C

INSTALLATION