GreenBrook DHT01A-C Instructions For Use

INSTRUCTIONS FOR USE
DOORCHIME WITH BUILT-IN
TRANSFORMER AND BELL PUSH
MODEL NUMBER: DHT01A-C
• Dual tone chime
• Powered by internal transformer
• Bellpush and woodscrews are supplied
SWITCH OFF THE MAINS AND
ISOLATE THE SUPPLY BY REMOVING THE
APPROPRIATE FUSE BEFORE STARTING
THE INSTALLATION
Diagram 1
1. Remove front cover by unscrewing the
small screw at the base of cover.
Diagram 2
2. Feed bell-push wire into top of chime
base and connect to terminals 0 and 2.
3. Remove transformer cover (Dia 3).
Diagram 3
4. Feed 230V mains Supply cable into the
bottom of the chime base (Dia 2)
5. Connect the Live (Brown) wire to
the"L" terminal and the Neutral (Blue)
wire to the "N" terminal (Dia 3)
6. Replace the transformer cover and
front cover.
7. Test unit by pushing bell push.
Do not mount chime on door
Recommended maximum overall
length of bell wire for doorchime
with built-in transformer:
SWG 21 (0.5mm
SWG 19 (0.75mm
PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
West Road, Harlow,Essex
CM20 2BG
E mail gbe@greenbrook.co.uk
Web page www.greenbrook.co.uk
Issue number: 701403
) - 30 metres
2
2 ) - 45 metres