Roland V-Drums TD-50X Quick Start Manual page 8

Getting Ready
Bottom Panel
Mounting the TD-50X on the stand
You can attach the TD-50X to a drum stand by using the sound module mounting
plate included with the drum stand (sold separately: MDS series, PDS series).
Using the screws on the bottom of the TD-50X, attach it as shown in the illustration.
* Do not use any screws other than the screws from the bottom of the TD-50X. Doing
so will cause malfunctions.
* When turning the unit over, be careful so as to protect the buttons and knobs from
damage. Also, handle the unit carefully; do not drop it.
MEMO
The All Purpose Clamp (APC-33; sold separately) can be attached to a pipe of 10.5–28.6
mm radius in case you want to mount the TD-50X on a cymbal stand or other such
stand.
Rear Panel (Connect Your Equipment)
Pads
(digital connection)
A
[L] switch
Turns the power on/off.
AC IN jack
Connect the included power cord here.
B
MIDI port
Use these connectors to connect an external sound module or
other MIDI device.
C
FOOT SW jack
You can connect a footswitch (BOSS FS-5U, FS-6; sold separately)
here and use it to control various things.
D
DIRECT OUT (BALANCED) jacks
Connect these to your mixer.
Use the [SETUP] button to specify the DIRECT OUT 1–8 jack from
which each instrument is output.
* Pin assignment of the DIRECT OUT
(BALANCED) jacks
8
External sound module or Footswitch
other MIDI device
A B
H
G
Pads
Wide
Narrow
Mixer Sampling pad or
other electronic
musical instrument
C D
E
E
MIX IN (STEREO) jack
Connect this to an electronic musical instrument such as a
sampling pad.
F
MASTER OUT (BALANCED) jacks /
MASTER OUT (UNBALANCED) jacks
Connect these to your mixer, amplified speakers, or recording
device.
If you want to output in mono, connect only the L/MONO jack of
the MASTER OUT (UNBALANCED) jacks.
* Pin assignment of the MASTER
OUT (BALANCED) jacks
G
TRIGGER IN jack
Connect cymbal, hi-hat, kick, and other pads here.
* If connecting a dual trigger type pad, use a stereo (TRS) cable.
H
DIGITAL TRIGGER IN jack
Connect pads that support digital connection (e.g., PD-140DS, CY-
18DR or VH-14D) here.
Sound module
mounting plate
Mixer or amplified speakers
F