RAIS/attika Viva 100 L Gas User Manual page 100

attika
English RAIS/ - User manual for VIVA L Gas
Chimney/Flue
This stove must be either installed with a vertical terminal (C31) or a horizontal terminal
(C11)
Must only be installed with a flue with a balanced draught (also known as a concentric
draft) as stated by RAIS.
The flues approved by RAIS are approved for use with the stove. If the stove is installed
with flues other than those approved by RAIS, RAIS cannot guarantee or accept respon-
sibility for the correct and safe functioning of the stove. and will invalidate the CE mark.
RAIS recommends that the stove be installed with a chimney of the following make:
On-Top-Metalotherm USD or On-Top-Metalotherm US.
Other approved chimney products are: Jeremias, Muelink & Grol, Poujoulat PGI.
Joints at vent pipes must be airtight and protected against separation by using locking
bands, or suitable rivets / screws.
If possible a measuring connection piece should be installed on the flue in the same
room as the stove so that a combustion check can be performed. Where the terminal is
accessible, this is unnecessary.
Ensure the flue terminal position complies with Building Regulations Approved Docu-
ment J, BS EN 5440-1 and the label in these instructions
Ensure that flue products cannot re-enter the property even if compliant with the regu-
lations. If the terminal is below 2m above ground level, a terminal guard must be fitted.
Flue assembly must follow the flue manufacturer's instructions.
The chimney is the driver for getting the stove to work. The stove will not work opti-
mally unless there is the necessary and correct draught in the chimney.
The stove is supplied with smoke connecting pieces prepared for internal assembly of
the outflow pipe.
with diameter Ø100/ø150
26