Refueling The Vehicle - Chrysler 300 2021 Owner's Manual

CAUTION!
To avoid vehicle damage, ParkView should

only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must

be driven slowly when using ParkView to be
able to stop in time when an obstacle is
seen. It is recommended that the driver
look frequently over his/her shoulder when
using ParkView.
It is recommended that the driver look

frequently over his/her shoulder when
backing up, especially in sunny weather
conditions, since there may be a glare from
the sun at certain angles that can make the
image on the touchscreen difficult to see.
NOTE:
If snow, ice, mud, or any foreign substance
builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do
not cover the lens.

REFUELING THE VEHICLE

1. Push the fuel filler door release switch
(located in the driver's door map pocket).
Fuel Filler Door Release Switch
2. Open the fuel filler door.
Fuel Filler Location
STARTING AND OPERATING
NOTE:
In certain cold conditions, ice may prevent the
fuel door from opening. If this occurs, lightly
push on the fuel door to break the ice buildup
and re-release the fuel door using the inside
release button. Do not pry on the door.
3. There is no fuel filler cap. Two flapper doors
inside the pipe seal the system.
4. Insert the fuel nozzle fully into the filler pipe
– the nozzle opens and holds the flapper
doors while refueling.
5. Fill the vehicle with fuel – when the fuel
nozzle "clicks" or shuts off the fuel tank is
full.
6. Maintain nozzle in filler for five seconds to
allow nozzle to drain.
7. Remove the fuel nozzle and close the fuel
door.
NOTE:
A funnel is provided (located in the trunk in the
spare tire area) to open the flapper doors to
allow for emergency refueling with a gas can.
131
4