Waterpik Water Flosser WF-10 Quick Start Manual

QUICK START GUIDE
WF-10
1
Unit Prep
OFF
Charge Unit for
4 Hours Prior to
First Use.
Plug
A. Plug power cord into
outlet and connect the
charging cord to the unit.
2
Water Floss
A. With unit OFF, place tip in
mouth. Turn power ON. Start
on low pressure, by pressing
the power button once. Press
twice for high pressure.
TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
This device is compatible with global voltages of 100 - 240 VAC, 50/60 Hz.
Insert
B. Press tip firmly into unit,
until it clicks into place.
To remove tip, push the tip
eject button.
Low
B. Lean over sink. Close lips
enough to prevent splashing.
Keep unit upright during use
to ensure continuous water
flow.
Register your product and
receive over $50 in savings.
waterpik.com/registration
Visit waterpik.com/welcomeWF
to watch How To Video
Caution:
Do not press
tip eject
button while
unit is running.
C. Disconnect charging cord
from unit. Lift the flip top on
reservoir and fill with warm
water. Refill as needed.
C. Aim water at the gumline
at a 90 degree angle. Follow
the gumline and pause
briefly between teeth.
Fill
©2019 Water Pik, Inc.