Icom IC-756PRO Alignment Procedure page 13

T u n e r B o a r d
SWR
- Connect RF power meter
- Connect multi-meter to J14
- Set 29.7MHz, RTTY
- Ground J12 on the CTRL board
- Turn on the tuner
- Transmit
- Adjust C3 for minimum voltage
- Insert jumper plug to REMOTE jack
- Turn off the radio
- Hold both SSB and CW buttons, and turns radio back on (The radio should show "Setup Start menu")
- Repress "F5: TUNER" button (The radio should show "F5: START")
- Repress "F5: START" button (The radio should show "END"
- Remove jumper form J12