Advertisement
NRG Sensor Connections to Symphonie
Introduction
These instructions will assist you in connecting standard NRG sensors to a Symphonie
provide the default slope and offset for each sensor type. These default values are preloaded in the
PLUS
Symphonie
logger (except for iPack voltmeter and RMY Vertical Prop Anemometer) and the Symphonie
Data Retriever (SDR) software. The values are included here as a quick reference only - please see the
PLUS
Symphonie
manual for logger channel configuration.
Connections
SymphoniePLUS_Sensor_Connection_Instructions
|
Rev 2.0
|
23 February 2015
PLUS
logger and also
|
support@renewableNRGsystems.com
PLUS
||
1
Advertisement
Table of Contents
Related Manuals for NRG Systems SymphoniePLUS
Summary of Contents for NRG Systems SymphoniePLUS
- Page 1 PLUS NRG Sensor Connections to Symphonie Introduction PLUS These instructions will assist you in connecting standard NRG sensors to a Symphonie logger and also provide the default slope and offset for each sensor type. These default values are preloaded in the PLUS Symphonie logger (except for iPack voltmeter and RMY Vertical Prop Anemometer) and the Symphonie...
- Page 2 Default Slope and Offsets for Symphonie PLUS Both the Symphonie logger and SDR software come loaded with default slope and offset values for our standard sensors. Please note that these settings are specific to Symphonie and Symphonie PLUS and may not be the same values used for other data loggers.
Need help?
Do you have a question about the SymphoniePLUS and is the answer not in the manual?
Questions and answers