Advertisement
Step 2
On a bench assemble finger tight ES-FRS16-CBS-C1 to ES-FRS16-C1
Lift into place and insert hanger into rubber and V Band flare into Dump
Pipe. If fitting the XForce Dump Pipe (ES-FRS16-KITB)
DO NOT
use the ES-
FRS16-CBS-C1
Slide the ES-FRS16-02-C2 over the rear sub frame (from tailshaft side) then
finger tight bolt to ES-FRS16-C1 and then fit the ES-FRS16-VMKR and Tips.
Tighten all bolts (16mm) and nuts (14mm) from the rear to the front.
Check Tip alignment and tighten using a 6mm Allen Key.
Advertisement
