Safety - ABB SACE Emax 2 Manual

2 - Safety

Safety requirements
Warnings
5 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A
Figure 1
HAZARD! RISK OF ELECTRIC SHOCK! In accordance with the local laws in force,
disconnect all the electricity supplies when Ekip Touch is being assembled, installed,
serviced or decommissioned if persons who are not authorized to work in live
installations are present.
WARNING!
• detailed descriptions of the standard installation, operation, maintenance procedures and
principles for working safely are not included; it is important to note that this document contains
indications about safety and caution, against certain methods (concerning installation, operation
and maintenance) which could cause imjuries to the personnel, damage devices or make them
unsafe
• these warnings and alarms do not include all the conceivable methods of performing the
installation, operation and maintenance operations recommended by ABB and others, which
could be performed, or the possible consequences and complications of each conceivable
method, neither will ABB investigate all those methods
• anyone who is implementing procedures or using maintenance devices recommended by
ABB or not must check carefully that neither their personal safety nor the safety devices are
endangered by the installation, operation, maintenance method or by the tools used; contact
your nearest ABB representative for further information, explanations or specific problems
• this manual is written for qualified personnel only and is not intended to replace an adequate
training course or experience concerning the safety procedures of this device
• regarding products equipped with communication systems, the purchaser, installer or end
customer are responsible for applying all the IT security measures to prevent risks deriving from
connection to communication networks; among others, these risks include use of the product
by unauthorized persons, alteration of its normal operation, access to and modification of the
information
• the purchaser, installer or end customer are responsible for ensuring that safety warnings and
notices are affixed and moreover, that all points of access and operating devices are securely
blocked when the switchgear is left even momentarily unattended
• all information in this document is based on the latest product data available at the time of
printing. We reserve the right to make changes to the document at any time and without prior
notice.
WARNING! READ THIS MANUAL WITH CARE BEFORE INSTALLING, OPERATING OR
REPAIRING THE CIRCUIT-BREAKER
• file this manual with all the other available documents concerning the circuit-breaker
• to facilitate the work, these documents must be readily available when the CB is installed,
operated and serviced
• the unit must be installed in accordance with the environmental, electrical and mechanical
limitations described in the product documentation
• this circuit-breaker has been designed to operate with voltage and current values within the
rating plate limits: do not install in systems that operate at values exceeding these rated limits
• comply with the safety procedures required by your Company.
• do not open covers or doors, do not work on devices before having disconnected all circuits
from the electricity sources and after having made sure of this with a measuring instrument
HAZARD
ACCIDENTAL CONTACT WITH LIVE
POINTS CAN CAUSE SHOCK, BURNS AND
RESULT IN DEATH.
Do not try to use the product in any way, before
having read this instruction manual
ABB | SACE Emax 2
Introduction | 2 - Safety