Ferroli CONNECT Installation And Use Manual page 53

4) dhW temperatures (OpenTherm boilers only)
» Press the buttons
enter.
» Press the buttons
» Press "set"
Note: If the thermostat receives the data from the boiler, then it displays this value,
otherwise the setting range is 30 – 60°C.
5) Information from the boiler (OpenTherm boilers only)
» Press the buttons
» When " " is displayed, it means the data is not available in the boiler
» Press "set"
No. information
1 Flow set point
2 Flow probe
3 Return probe
4 DHW temperature
5 Outside temperature
6 Power percentage
7 DHW draw
8 System pressure
to select the DHW temperature, and then "set"
to change the value.
or "mode" to return to the previous menu.
to select information, and then "set" to enter.
or "mode"
to return to the previous menu.
cod. 3541S181 - Rev. 00 - 09/2020
to
53
EN